With output short-circuit protection function, it will be in hiccup protection mode when short-circuited. After the short-circuit is eliminated, the power output will be restored.Specs:Weight: 67g±3gInput: 18-75V (MAX3.9A)Output: 12V ±0.5% 3.5A (The rated output current when the input voltage is 18-36v / 4.2A (Rated output current at input voltage ..
Always worried about poor soldering and wasting expensive electronics? Well, Here it is the Blitz Practice Board Soldering Board , which will help steady that hand and give you perfect solder jobs in no time! The Practice Soldering Board replicates almost every common type of solder joint in the FPV world. You can practice tiny ..
Features:- Suitable for most CineWhoops on the market- The light strip supports plug-and-play, which can be directly plugged into the flight controller or LED light control board.- RGB color can be adjusted through the flight controller, Raspberry Pi, Arduino, etc., and can be adjusted according to your preferencesSpecs:Weight: 0.95g/pcSi..
Color: Green, red, Yellow is ProgrammableMaterial: PCB Package included:4pc x led Lights..
Item Name: Finder YR50B_SSize: 18*17*15MMWeight: 4gVolume: Up to 100dBFeatures:- Finder YR50B_S get po wer from Flight Controller.- Dual LED lights flash.- Much Louder than Standard BuzzerTo easily find the crashed quad in long distance,YR50B_S is designed to install a very loud beeper that the dB is over 100.-How to Disarm the BuzzerDisarm with bu..
UNICON UPL 35V 470UF Capacitors (5pcs)Capacitance:470uFVoltage: 35VMaximum Voltage: 160V / 125°CTemperature: -55+125°CSize: 10x12mmFeatures:Long life, low impedanceUsage: Main board, electric meter, high frequency switching power supply, power negative control power supply, etc.Battery usage and recommended capacitor Voltage number recomm..
BumbleBee HD Type C 90° Connector SPECIFICATIONSType C to Type C INCLUDES1pcs x BumbleBee HD Type C 90° Connector ..
It is used beteween the AIR UNIT and SucceX-D flight controller.Fit for SucceX-D F7 and SucceX-D mini F7 Length: 90mm (with plugs), wire length: 80mmDouble-ended 1.25-1.0mm terminal linePackage included:5pcs x 6 Pins Port cable for DJI Air Unit (5pcs)NOTE: THE AIR UNIT AND FLIGHT CONTROLLER DO NOT INCLUDE...
Rubycon 50v 470uf 10x20mm Capacitors (10pcs)Capacitance:470uFVoltage: 50VTemperature: -40-+105°CTolerance:+/-20%(120MHZ,+20°C)Size: 10x22mmPackage included:10pcs x 50v 470uf Capacitors ..
The led board has 5 super bright RBG LEDs, which can be installed as RGB LED Tail Light, arms, or other Betaflight LED addressable boards. The LEDs need 5v, ground and a signal source in order to work.The layout of the PCB board keeps wiring clean and neat with a 3 pin plug, it will make it easy to change out in case of a crash. It is pro..
The traditional race wires prevent damage to wires or even propeller strikes from dropping you out of the air, while also making motor swaps super fast and easy without the need to open up your quad to access your 4in1 ESC or AIO board. that is a kind of progress of professional development. However, there’s still an extra soldering job needed to b..
This micro-sized step-down voltage regulator is perfect for supplying 12v power (from a higher voltage source like 4S or 5S, even 6S Lipo) to your FPV gear that needs specifically 5V Range. Power 5V flight cameras, LED lights or other gear that can only run on 5V.The compact (14.5*6.6*2.6mm) size step-down voltage regulator takes an input vol..